Profibus DP Slave Interface

The hardware is based on the NP30 network processor developed by HMS, and has been tested at a test center and conforms to the latest specifications.

The Anybus-S Profibus-DP is available with a 2k byte parallel Dual Port Ram interface. Profibus station address can be selected via switches on the front side of the module or by software via the application interface. A bus termination switch is located on the front side of the module. A DC/DC converter and optocouplers are provided onboard.

The module is certified by the Profibus user organization and has proven conformance and interoperability with leading PLC´s from Siemens, Rockwell, ABB & Omron.


   POINTS CLÉS
  Complete Profibus-DP Slave functionality according to IEC 61158
  Automatic baud rate detection (9600 bit/s - 12 Mbit/s)
  RS-485 optically isolated Profibus interface with DC/DC converter on-board
  Full interchangeability with AnyBus-S modules for other networks
  Save/load configuration in flash supported
  AnyBus-S Starterkit and evaluation board available
  Up to 244 bytes input and 244 bytes output

  SPÉCIFICATIONS TECHNIQUES
Taille:   54 mm x 86 mm x 15 mm
Power Supply:   +5V max 350mA
Température:   0-70°C
Baud Rate:   Auto baudrate
I/O Input:   max 244 bytes (max 416 bytes IN + OUT)
I/O Output:   max 244 bytes (max 416 bytes IN + OUT)
Interface Appl:   Parallel
Profibus Services:   All mandatory + User parameter data, Device related data diagnos
ID number & GSD supp:   1003H with standard GSD file; may change if required
UL file:   E214107
Product Life Cycle:   Mature (not recommended for new in-designs)
Code:   AB4005