J1939 - Profibus Slave

The Anybus X-gateway PROFIBUS to J1939 enables a PROFIBUS-DP Master to read and write J1939 network data. The X-gateway accomplishes this by operating simultaneously as a PROFIBUS-DP Slave node on a PROFIBUS network and a CAN node on a J1939 network. The module exchanges data from either network based on a user defined configuration. HMS provides a free Windows-based configuration tool (BWConfig) that allows the user to map J1939 parameter (PGN) data into the module's input and output tables, accessible by the PROFIBUS Master over the PROFIBUS -DP network.

Example Use Cases
1. A low-cost interface used on Oil & Gas Equipment to access engine parameters from a Programmable Logic Controller (PLC), HMI or PC

2. An on-vehicle gateway used to interface a J1939 network to an onboard industrial automation based control & monitoring system or HMI

Target Industries & Applications
Oil & Gas Equipment
Marine Vessels
Commercial, Construction, Agricultural & Recreational Vehicles
Electric Power Generation (Diesel GenSets)
Water & Waste Water Systems
Engine Testing & Validation
Monitoring / Control Systems requiring J1939 data & control

  Supports SAE J1939 vehicle protocol over CAN and PROFIBUS -DP (Slave) Industrial Automation protocol.
  The AB7614 is a configurable gateway, allowing the user to configure the specific J1939 PGN messages to be transmitted or received by the module as well as the particular data within a PGN that is required for the users application.
  Supports FLASH field upgrades
  Rugged extruded aluminum enclosure
  The module now supports up to 35 incoming J1939 Transport Protocol (large message) sessions. Previously the module was limited to a single BAM and RTS/CTS session.
  The module can now monitor up to 120 different PGNs in the Input data point configuration and transmit up to 100 different PGNs in the Output data point configuration. The previous limitation was 50 and 50.
  The J1939 Transport Protocol (large message) handler now rejects incoming session requests (both BAM and RTS/CTS) for PGN/Address pairs that are not configured as input data points.
  The SPN Conversion Method Flag is now included in the high bit of the Occurrence Count field in the J1939 diagnostic table entries. See the important notes section above and the user manual for more details.

Puissance Mécanique:   IP20 / NEMA 1
EMC Compliance:   EN50081-2 and EN50082-2
Certifications:   CE & cULus
Price group:   A
US orders:   Contact HMS for US model numbers
Code:   AB7615