|Profinet IO Device - Modbus RTU Slave|
The Anybus X-gateway copies I/O-data in both directions thus enabling data exchange between the two networks. Default I/O configuration is 20 bytes Input and 20 bytes Output. Changing default settings is very easy using the windows based configuration software Anybus Configuration Manager X-gateway from HMS (free of charge).
The Anybus OPC Server is supported and included with this X-gateway. It enables fast and dynamic transfer of fieldbus data to and from e.g. SCADA/HMI/Enterprice level systems based on Microsoft Windows.
The Profinet IO interface is a complete solution for a Profinet IO slave Device. The module is based on the Siemens Profinet IO software technology.
The Profinet IO baudrate is 100Mbit/s (full duplex). The IP-address and additional IP-settings is easily configured with the Anybus IPconfig utility for Windows. Additional ways to set the IP-address are either via DHCP or the Profinet configuration tool. Four diagnostic LEDs will continuously indicate the actual Profinet IO status and possible error messages. The Profinet IO interface uses a normal RJ45 connector for the bus connection.
IT-functions like WEB-server, E-mail client, FTP-server are also supported. The IT functions can be used simultaneously with the Profinet IO communication.
Modbus/TCP is also supported with "Read Data" functions.
The Modbus RTU Slave interface is implemented according to Modbus Protocol ref guide (PI-MBUS-300). All data is mapped to 3x and 4x Modbus areas meaning the Input Status and Output Register Word areas. The Modbus RTU standard baudrate is 19200 Bit/s but can be modified on the gateway between 1200 Bit/s to 57 600 Bit/s.
|Modbus RTU transmission media RS485|
|Supported Modbus RTU functions: 1, 2, 3, 4, 5, 6, 8, 15, 16, 22, 23|
|Gateway diagnostics via WEB-pages|
|Profinet 100 Mbit/s twisted pair RJ45 conn...|
|Profinet IO and IT functions|
|Profinet 100 Mbit/s twisted pair RJ45 connection|
|1 Mbyte storage space on Flash disc|
|TCP/IP settings configurable with Profinet config tool, Anybus IPconfig or DHCP|
|Support for Anybus OPC Server|
|Taille:||114 mm x 44 mm x 127 mm|
|Power Supply:||24 VDC (±20%)|
|Consommation:||max 400 mA at 24V|
|I/O Input:||Default 20 bytes, max 512 bytes|
|I/O Output:||Default 20 bytes, max 512 bytes|
|Power supply connect:||2-pole 5.08 mm Phoenix pluggable screw connector|
|Profinet address:||Any valid IP-address|
|Modbus RTU baudrate:||1200 Bit/s to 57 600 Bit/s|
|Modbus RTU address:||Node address 1-247|
|Modbus RTU connector:||D-sub 9-pin female|